Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Jerome, ID

CHI Overhead Doors Garage Door Roller Replacement in Jerome, ID

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

Need CHI Overhead Doors garage door roller replacement in Jerome, ID? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. We work on CHI Overhead Doors garage doors of every age, from older models to current lines, and carry or can source compatible parts. CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Is it time for CHI Overhead Doors garage door roller replacement?

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

What usually causes it

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

What you can check yourself

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle CHI Overhead Doors garage door roller replacement

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

How much does CHI Overhead Doors garage door roller replacement cost?

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other CHI Overhead Doors services

Serving Jerome, ID and nearby towns

Large daily temperature swings in Idaho work hinge screws and track bolts loose, which leads to noise, wobble and eventually an off-track door.

Our CHI Overhead Doors garage door roller replacement service covers Jerome (ZIP code 83338) and nearby towns including Wendell (10.1 mi), Twin Falls (11.5 mi), Filer (11.6 mi) and Buhl (15 mi). Call (833) 435-8883 to book a visit in Jerome.

CHI Overhead Doors Garage Door Roller Replacement: frequently asked questions

How much does CHI Overhead Doors garage door roller replacement cost in Jerome, ID?

CHI Overhead Doors Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do CHI Overhead Doors garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is CHI Overhead Doors garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and CHI Overhead Doors warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Idaho or Jerome requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Jerome, ID

Raynor Garage Door Opener Installation

New chain, belt, screw-drive and wall-mount openers installed and programmed.

Typical $350-$800

McKeon Door Rolling Fire Door Inspection & Drop Testing

McKeon makes rolling fire doors, fire curtains and rolling steel doors.

Typical $150-$500

Cornell Cookson Rolling Fire Door Inspection & Drop Testing

Cornell Cookson makes rolling steel service doors, security grilles and rolling fire doors.

Typical $150-$500

Windsor Door Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Marantec Garage Door Opener Installation

Marantec is a German manufacturer of residential and commercial door openers.

Typical $350-$800

Commercial Overhead Door Installation

Commercial sectional, insulated and high-cycle doors and operators installed.

Typical $2,500-$12,000

Linear Garage Door Sensor Repair

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $100-$250

Stanley Opener Gear & Sprocket Replacement

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $125-$275

Ryobi Opener Gear & Sprocket Replacement

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $125-$275

Battery Backup Opener Installation

Openers with battery backup so the door works during power outages.

Typical $450-$950

Haas Door Garage Door Panel Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $300-$900

Wayne Dalton Torsion Spring Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $200-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Jerome, ID now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote